How to set number of simulations

General discussion and questions about project risk management and risk analysis software RiskyProject. Includes discussion on how to perform efficient project risk analysis using our software.

Moderator: Intaver Support

Post Reply
Interstate
Posts: 12
Joined: Mon Mar 06, 2006 6:08 pm

How to set number of simulations

Post by Interstate » Mon Jan 09, 2012 11:37 am

Hi,

I am required to run a minimum number of iterations for a simulation. Everytime I run one it seems to finish to early. How do I set the number of iterations in the Monte Carlo Simulation?

Thank you for any suggestions

Intaver Support
Posts: 823
Joined: Wed Nov 09, 2005 9:55 am

Re: How to set number of simulations

Post by Intaver Support » Thu Jan 12, 2012 4:56 pm

1. Go to Schedule tab, Settings and Options group and click Options
2. Click the Calculation tab
3. Set the maximum number of simulations in the Maximum number of simulations fields.

Note: If you have convergence enabled (Stop simulations when converged) the simulations may end before the max number is reached.

This information is available in the online Help topic
http://www.intaver.com/Help4/RP_Help.ph ... tions.html

I hope that this was of some help.

Intaver Support
Intaver Support Team
Intaver Institute Inc.
Home of Project Risk Management and Project Risk Analysis software RiskyProject
www.intaver.com

Post Reply