Low number of Sensitivity Results

This forum includes discussion about project risk analysis and risk management theory: Monte Carlo simulations, Event Chain Methodology, schedule and cost risk analysis. Please submit questions and case studies about your experience with our project risk analysis software.

Moderator: Intaver Support

Post Reply
Posts: 15
Joined: Mon Mar 06, 2006 6:08 pm

Low number of Sensitivity Results

Post by Interstate » Wed Mar 20, 2024 9:57 pm

We have been running simulation on a large schedule, but only seeing a few results in the Sensitivity View. Is there a way to see more results?

Intaver Support
Posts: 995
Joined: Wed Nov 09, 2005 9:55 am

Re: Low number of Sensitivity Results

Post by Intaver Support » Wed Mar 20, 2024 10:10 pm

Best Practice: Setting Sensitivity Coefficient Threshold

There is a threshold that can be set for viewing sensitivity results, where any results that do not meet the sensitivity coefficient threshold are not show as way to simplify the analysis of schedules. If you many activities with similar levels of risk and uncertainty, the sensitivity coefficients will often fall below the default setting.

The Sensitivity Threshold is set in the Project Options > Calculations tab. You can experiment with the coefficient to see the level that provides the number of results that you want to view.

Intaver Support Team
Intaver Institute Inc.
Home of Project Risk Management and Project Risk Analysis software RiskyProject

Post Reply